DZP30 30g Coaxial Dual Brushless Motor Counter-Rotating No-Torque for F3P Model Airplane with Propellers
Version 1: Counter-Rotating Motor & Propeller Set
Version 2: Counter-Rotating Motor Combo - Pre-soldered ESCs & Props
Version 3: Counter-rotating Motor with GWS8045 Two-Blade Props
Version 4: Counter-rotating Motor with GWS8045 Two-Blade Props

Product Description
KV Rating: 1500
Weight: 32g (Motor only, excluding accessories and propeller)
Recommended Propeller:
A pair of GWS7035x3 propellers (one normal rotation, one reverse rotation).
The reverse rotation propeller should be installed on the front and requires a 6mm adapter ring.
The normal rotation propeller is installed on the rear and needs to be reamed to an 8mm bore.
Package Includes:
Motor Body × 1
Front Propeller Mount × 1 set
Rear Propeller Clamp Plate × 1
Standoff Pillars × 4
Mounting Cross Plate × 1
Screws × 8
L-Wrench × 1
GWS 7035 Three-Blade Propellers (Normal & Reverse rotation, including adapter rings) × 1 pair
Note: Propeller color may vary.
Performance Data (No Load):
Current: 0.5A per motor @ 11.1V
Maximum Thrust:
280g per motor @ 11.1V / 5.1A per motor
Alternative Propeller Data (GWS8043 Two-Blade):
Test Conditions: 7.4V, 5.2A per motor
Thrust: 240g per motor
size:

Important Notes for Customers Who Have Purchased the Combo with ESCs, Receiver, and Transmitter:
Power Connection: The common power input port for both ESCs is pre-soldered with a 2S balance plug (female). If you are using a 2S 7.4V LiPo battery, you can plug it in directly.
ESC-to-Receiver Connection: To prevent incorrect wiring, the shared Y-harness for the two ESCs has been pre-plugged into the receiver as a demonstration. Please do not unplug it, as the pin order of the receiver connector must be correct.
Initial Setup & Safety:
Assemble the motors as shown in the video.
After securing the motors, connect the ESCs.
Then connect the battery.
For initial startup, DO NOT install the propellers to avoid any danger.
Binding Procedure:
After powering on, the red LED on the receiver will blink rapidly, indicating it is in binding mode.
Press and hold the bind button on the transmitter, then turn the transmitter on. Release the button. The screen will display "BINDING".
Once the red LED on the receiver changes from rapid blinking to solid, the binding is successful.
Then, turn off the power for both the transmitter and the receiver/power system.
For future use: always turn on the transmitter first, then power up the receiver. The system will connect automatically without needing to re-bind.
You will hear two short beeps from the motors, indicating the ESCs have received the signal. You may then advance the throttle to start the motors.
Additional Tip:
If you have previously used two-blade propellers, the front propeller collet may not grip tightly and could slip. This is because the set screw is very small. We recommend using a 3mm self-tightening propeller collet instead. A squeeze-type 3.0mm collet is also a suitable option.






下两图是接线方式,仅供参考!










