The receiver supports WIFI connection and firmware flashing, which is convenient and fast
Equipped with a power amplifier (PA+LNA), it has a telemetry output of 100mW and better response speed
Theoretically compatible with all ELRS 2.4G transmission modules on the market (provided firmware version 3.0 or above)
ELRS 915MHZ RX
Frequency range: 915MHz FCC
Maximum refresh rate for reception: 500Hz
Minimum refresh rate for reception: 25Hz
Working voltage 5V
Weight: 0.6g (excluding antenna)
Firmware: BETAFPV-900_SX3.2.0
Size: 11mm * 17mm * 4mm
Indicator light status:
Double Flash: Code Matching Mode
Slow flashing: No transmission signal received
Always on: Received transmission signal
Flash: WIFI upgrade mode
Frequency steps:
After connecting the receiver to the flight controller, connect the USB to power the flight controller. After inserting the USB for the first time, when you see the
Immediately disconnect the USB when the LED light goes out. Repeat the operation twice. When the USB is inserted for the third time, the LED will start flashing twice, and the receiver will
Enter code pairing mode
2. After correctly connecting the 915M (868M) ELRS high-frequency head module to the remote control, copy the ELRS.LUA file to the remote control
On the SD card, the directory is SD Card/Scripts/tools, and then run ELRS.LUA to perform the Bind operation.
After successful binding, the LED on the receiver will turn on normally and telemetry signals can also be received.
Shipment includes:
Receiver * 1
Plug in * 1
T-shaped antenna * 1
Heat shrink tubing * 2



