Product Introduction:
Compatibility: Compatible with all unidirectional and bidirectional DSM2/DSMX mode transmitters
Specifications:
Volume: 48 * 2514mm
Weight: 15G
Working voltage: 4.5-9.5V
Working current: 45MA
Response speed: 11ms/22ms
Resolution: 1024/2048
Compared to other DSM2/X dedicated high gain antennas, it uses a high gain amplifier internally, which is stable and has a long distance. (Distance is 1 time farther than the same type of receiver)
Although F801 does not display PPM channel on the image, it can be plugged into the fifth channel as a PPM channel with PPM function when in use
Installation:
Code process and out of control protection settings:
1. Insert the receiver into the code bar, press and hold the switch on the code bar to power on the receiver, and the code light will flash rapidly. Release the switch on the code bar, lower the throttle of the transmitter, press and hold the code switch to turn on the power of the transmitter, enter the code state, and the receiver will flash slowly until the code light on the receiver stays on. This indicates that all channels have out of control protection. 2. Insert the receiver into the code bar, hold down the switch on top of the code bar, do not release it, power on the receiver, the code light flashes rapidly, pull out the code bar, lower the accelerator of the transmitter, hold down the code switch to turn on the power of the transmitter, enter the code state, the receiver flashes slowly until the code light of the receiver stays on. This indicates that the accelerator has out of control protection status, and other channels do not have out of control protection. C) Ppm output, during the above code matching process, after matching the code, press the code bar button again. The ppm signal monitoring light stays on and outputs ppm in the fifth channel, while the other channels do not output.
Signal loss indication:
In some special cases, such as strong interference, the signal may be lost. When the signal is briefly lost, the receiver will continue to try to find the transmitter while maintaining the last command received from the transmitter until a new command is received
The control distance is also affected by the environment. Please test and use it outdoors away from any obstacles. The control distance in the air is greater than the distance on the ground. The control distance we obtained is based on ground testing.
